Εμφάνιση περισσότερων

    Video screenshots

    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 1
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 2
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 3
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 4
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 5
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 6
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 7
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 8
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 9
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 10
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 11
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 12
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 13
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 14
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 15
    • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 16

    With the oxygen gas cylinder I implanted the straw in the glade and then there were many extreme cumshots.

    Δημοσίευση από Excitado28

    Σχόλια
    3
    Παρακαλούμε ή για να δημοσιεύετε σχόλια
    richard132
    Hallo was hast du da für Gas genommen ? Lg Richard 
    Απάντηση
    Fkkficken
    Langweilig. Was soll das
    Απάντηση
    Yayyy!!! You tried! Thank you. Melt the end with a lighter slightly to round off the sharp edge of that plastic. Also, you may want to cut the last 1/4" off the end first because I think the second graduation up will fit you just fine, perfectly in fact. That first stem is too long for now. Just be sure to melt the edges slightly with a lighter, rounding the edges off while it's still maliable with your fingers. Let it cool then send it in a little slowly going about half an inch. Tape it there if you need, which will free that hand to use elsewhere. Good job bro. Hot to finally see this . I knew you could do it. HOTAF
    Απάντηση

    Κατηγορίες